If you didn't find what you were looking for, try a new search!
Advance Sensors & Modules Kit Product name QYT JoyStick 1 Flame Sensor 1 BMP 180 1 Heartbeat Sensor 1 NTC Thermistor Senosr 1 Temperature And Humidity Sensor DHT-11 1 IR sensor 1 Passive Buzzer module 1 Sound Sensor 1 Vibration Sensor 1 Moisture Sensor 1 Ultrasonics Sensor 1 Gas Module 1 Alchole Sensor 1 3-Axis
Specifications & Features of MAX30100 Pulse Oximeter Heart Rate Sensor Module:- It is an integrated pulse oximetry and heart rate monitor sensor solution. Integrated LEDs, Photo Sensor, and High-Performance Analog Front -End Complete Pulse Oximeter and Heart-Rate Sensor Solution Simplifies Design Measures absorbance of pulsing blood I2C interface plus INT pin Tiny 5.6mm x 2.8mm x
Specifications & Features of BMP180 Digital Barometric Sensor Module compatible:- 1.8V to 3.6V Supply Voltage Low power consumption – 0.5uA at 1Hz I2C interface Max I2C Speed: 3.5Mhz Very low noise – up to 0.02hPa (17cm) Fully calibrated Pressure Range: 300hPa to 1100hPa (+9000m to -500m)
Specifications & Features of Water Level Depth Detection Sensor:- Operating voltage: DC3-5V Operating current: less than 20mA Sensor Type: Analog Detection Area: 40mmx16mm Operating temperature: 10℃-30℃ Humidity: 10% -90% non-condensing
Specifications & Features of Soil Moisture Meter, Soil Humidity Sensor, Water Sensor, Soil Hygrometer:- Dual output mode, analog output more accurate A fixed bolt hole for easy installation With power indicator (red) and digital switching output indicator (green) Having LM393 comparator chip, stable. Operating Voltage: 3.3V~5V
Specifications & Features of Vibration Sensor Module SW-420:- Using SW-420 normally closed type vibration sensor Comparator output, clean signal, good waveform, strong driving ability, >15mA Operating voltage 3.3V ~ 5V Output format: digital switching output (0 and 1) Using a wide voltage LM393 comparator With bolt holes for easy installation
Specifications & Features of Sound Detection Sensor Module:- Operating voltage 3.3V-5V Outputs digital switching output (high and low levels 0 and 1 Operating current (Vcc=5V): 4-8mA Microphone sensitivity (1Khz): 52-48dB Microphone Impedance: 2.2KΩ Microphone Frequency: 16-20Khz Microphone S/N ratio: 54dB Signal output indication Single channel signal output Outputs low level and the signal light when
Specifications & Features of Pulse Sensor - Heart Rate Detector:- A Color-Coded Cable, with a standard male header connectors. Plug it straight into an Arduino or a Breadboard. No soldering is required. The Pulse Sensor has 3 holes around the outside edge which make it easy to sew it into almost anything. Visualization software (made
Specifications & Features of Flame Sensor infrared Receiver Ignition source detection module:- Indicator light: a green one for the switch, a red one for power. Built in a potentiometer for sensitivity control. Onboard signal output indication, output effective signal is high, at the same time the indicator light up, the output signal can directly connect
Specifications and Features of MQ-3 Alcohol Detector Gas Sensor Module:- Signal output light indicator. Analog and level signal output. TTL output valid signal is low. (When the output low signal light can be directly connected microcontroller or relay module). The carbon monoxide detection with better sensitivity. It has a long service life and reliable stability.
