Overview The Elecronics V3 Board is a low-cost evaluation and […]

Specification & Features of USB Logic Analyze: -

1. Logical light indication: a small light indicates CHO electrical level.
2. Input feature: 5PF,100K Ohm.
3. USB power supply; USB logic analyzer for monitoring, analyzing and debugging digital circuits.
4. 8-Channels USB logic analyzer with a 24Mhz sampling frequency
5. Can analyze UART, IIC, and SPI, etc. automatically.
6. Great for MCU, ARM system and FPGA development
7. Voltage: 0-5.5V

Specification of STM32 ECU: -

• Power Electronics.
• Environmental Monitoring.
• Home Automation.
• Embedded Systems Development.
• IoT (Internet of Things) Prototyping.

--------------------------------------------------------------- Technical Specifications and Features of Innomaker: - ---------------------------------------------------------------

• Compatibility: Raspberry Pi Zero(W)/Pi3B+/PI4/Beagle bone/Tinker Board and any single-board computer.
• Power: USB-powered, no external power required.
• CAN Baud Rate: Supports a broader range of CAN baud rates, from 20Kbps to 1Mbps and both CAN bus 2.0A and 2.0B specifications, ensuring compatibility with a wide range of CAN-enabled devices.
• Microcontroller: Onboard STM32F0 microcontroller with DMA technique.
• Protection: Power supply isolation, signal input/output isolation, surge/static protection, selectable 120-ohm resistor.
• Software Support: C/Python demos of Socket-CAN, InnoMaker Windows/MacOs/Linux Soft_API.
• Certifications: CE and FCC certified.

Specifications and Features: -

1. Blister Card
2. Phosphor bronze plating spring clip
3. Matching jumper, the diameter of 0.8mm
4. Use: experiment, test
5. Features: recycling, recycling, Color clear structure, easy to use

Specifications & Features of JLink V9 Debugger Emulator: -

• The main control chip adopts STM32F205, not lose firmware, and the hardware is upgraded to the latest version of V9.4
• Can provide 3.3V and 0.8A current for the development board (pin 2)
• Support standard JTAG interface and 2-wire SWD debugging interface. The speed can reach 20M (JTAG) / 15M (SWD) per second.
• Support debugging of all ARM chips, support MDK or IAR, and compile environment IDE supported by other standard JLink.
• Original firmware, full automatic upgrade The main control chip adopts STM32F205, without losing the firmware, and the hardware is upgraded to the latest version of V9.4

Key Features

• NXP S32K344EHT1VPBST chipset
• Wide input voltage range: 6V to 17V
• Input power monitoring via INA219
• USB Type-C for power supply
• Switchable voltage for VDD_HV_A bus (3.3V or 5V)
• Onboard Segger J-Link debugger
• Onboard USB to UART converter (CP2102)
• Three CAN FD transceivers
• One 100Base-T1 Ethernet transceiver
• Two LIN transceivers
• 64Mb QSPI flash memory
• Two user-programmable switches
• Two RGB LEDs
• 16 MHz high-speed external oscillator (HSE) and 32.768 kHz low-speed external oscillator (LSE)
• High-precision (3.3V ± 0.2%) voltage reference for ADC