Specification & Features of USB Logic Analyze: -

1. Logical light indication: a small light indicates CHO electrical level.
2. Input feature: 5PF,100K Ohm.
3. USB power supply; USB logic analyzer for monitoring, analyzing and debugging digital circuits.
4. 8-Channels USB logic analyzer with a 24Mhz sampling frequency
5. Can analyze UART, IIC, and SPI, etc. automatically.
6. Great for MCU, ARM system and FPGA development
7. Voltage: 0-5.5V

Transistor is a semiconductor device used to amplify or switch […]

Touch Pad will have EIGHT TERMINALS. In them four are […]

A Thermistor Ntc is a thermally sensitive resistor that exhibits […]

Temperature sensor module is low cost, small size module. It […]

Step Down transformer is a type of transformer that converts […]

A SOLDERLESS BREADBOARD, or protoboard, is a construction base for […]

Specifications & Features of SIM900A Wireless GSM GPRS Module with Antenna:-

• Quad-Band GSM/ 850/900/1800/1900MHz
• Compatible with arduino, raspberry pi, arm, avr, pic, 8051
• power supply 12v 1amp to 2 amps max
• Use in the area of full signal strength.
• Perfect suited for GSM based Microcontroller Projects (better than SIM300 and other GSM Modems)
• Option for connecting MIC and SPEAKER directly to GSM MODEM for calls (LINE IN also available)
• Supports communication through RS232 with DB9 Connector, TTL Pins and I2C Pins
• CALL SMS GPRS facility - MIC input, LINE input and SPEAKER output pins

Specifications & Features of SIM800L GPRS GSM Module Micro SIM Card Core Board Quad-band TTL Serial Port:-

• Quad-band 850/900/1800/1900MHz - connect onto any global GSM network with any 2G SIM (in the USA, T-Mobile is suggested).
• Make and receive voice calls using a headset or an external 8Ω speaker and electret microphone.
• PWM/Buzzer vibration motor control
• AT command interface with "auto baud" detection
• Send and receive SMS messages.
• Send and receive GPRS data (TCP/IP, HTTP, etc.).
• Scan and receive FM radio broadcasts.
• Lead out buzzer and vibration motor control port.
• AT command interface with "auto baud" detection.
• Onboard IPEX socket that can be connected to external antenna.

Specification and Features :-

• Model: SG90
• Weight: 9 gm
• Operating voltage: 3.0V~ 7.2V
• Servo Plug: JR
• Stall torque @4.8V : 1.2kg-cm
• Stall torque @6.6V : 1.6kg-cm

• S32K144 MCU in LFQP100 pin package.
• onboard RGB LED and 2 switches
• 1 Variable Potentiometer
• On-board UART for debugging via Type C USB cable
• On-Board CAN transceiver IC TJA1051 via green screw Terminals.
• TX-RX LED indicator pins for onboard UART and CAN communication.
• Onboard JTAG-SWD 10-pin Connector for JLink SWD Debugging