Specification & Features of USB Logic Analyze: -
- Logical light indication: a small light indicates CHO electrical level.
- Input feature: 5PF,100K Ohm.
- USB power supply; USB logic analyzer for monitoring, analyzing and debugging digital circuits.
- 8-Channels USB logic analyzer with a 24Mhz sampling frequency
- Can analyze UART, IIC, and SPI, etc. automatically.
- Great for MCU, ARM system and FPGA development
- Voltage: 0-5.5V
- S32K144 MCU in LFQP100 pin package.
- onboard RGB LED and 2 switches
- 1 Variable Potentiometer
- On-board UART for debugging via Type C USB cable
- On-Board CAN transceiver IC TJA1051 via green screw Terminals.
- TX-RX LED indicator pins for onboard UART and CAN communication.
- Onboard JTAG-SWD 10-pin Connector for JLink SWD Debugging
Specifications & Features of JLink V9 Debugger Emulator: -
- The main control chip adopts STM32F205, not lose firmware, and the hardware is upgraded to the latest version of V9.4
- Can provide 3.3V and 0.8A current for the development board (pin 2)
- Support standard JTAG interface and 2-wire SWD debugging interface. The speed can reach 20M (JTAG) / 15M (SWD) per second.
- Support debugging of all ARM chips, support MDK or IAR, and compile environment IDE supported by other standard JLink.
- Original firmware, full automatic upgrade The main control chip adopts STM32F205, without losing the firmware, and the hardware is upgraded to the latest version of V9.4
PROJECTS CODE Download The Arduino ide Software Try it for […]
PROJECTS CODE Download The Arduino ide Software Try it for […]
Specifications & Features of JLink V9 Debugger Emulator: -
- Type C cable Powered and connection to Host Desktop/Laptop
- Works on SWD protocol for programming and debugging the NXP S32K1xx and NXP S32K3xx Series of MCU's.
- Configured as Jlink Debugger for Programming/Debugging via S32 Design Studio/FreeMaster/ MBDT/Jlink Software Toolchain
- 2 Debug Connectors to connect to Host NXP Semiconductors S32K Microcontroller's: 20 Pin JTAG and 10 Pin SWD connector
- Power configurable to Host NXP S32K MCU between 3.3 V and 5V.
- Can provide 3.3V or 5V and uptp 1A current for the development board by powering the S32K MCU via ProBug Debugger.
- Onboard Reset Button to reset the Host NXP S32K MCU via Debugger and also Power/Communication LEDs.
- Virtual UART COM Port Detection via same Debug connector for logging Realtime data via UART Peripheral.
Key Features
- NXP S32K344EHT1VPBST chipset
- Wide input voltage range: 6V to 17V
- Input power monitoring via INA219
- USB Type-C for power supply
- Switchable voltage for VDD_HV_A bus (3.3V or 5V)
- Onboard Segger J-Link debugger
- Onboard USB to UART converter (CP2102)
- Three CAN FD transceivers
- One 100Base-T1 Ethernet transceiver
- Two LIN transceivers
- 64Mb QSPI flash memory
- Two user-programmable switches
- Two RGB LEDs
- 16 MHz high-speed external oscillator (HSE) and 32.768 kHz low-speed external oscillator (LSE)
- High-precision (3.3V ± 0.2%) voltage reference for ADC